Standalone Universal Device Programmer For Electrical Lab Training

FEATURES ·Programs high-density Flash memory devices at near theoretical minimum programming times (Program+verify INTEL28F320W18, 32Mb less than 13.5s) Device Support ·  EPROM, Paged EPROM, Parallel and Serial EEPROM, FPGA Configuration Serial PROM, FLASH Memory (NOR and NAND), BPROM, NVRAM, SPLD, CPLD, EPLD, Firmware HUB, Microcontroller, MCU, Standard Logic. Package Support ·  DIP, SDIP, PLCC, JLCC, SOIC, QFP, TQFP, PQFP, VQFP,TSOP, TSOPII, SOP, PSOP, TSSOP, SON, EBGA, FBGA, VFBGA, µBGA, CSP, SCSP etc. ·  Standard 48 pin universal pin-drivers in universal package. No adapters are needed for DIL devices. ·  Universal pin-drivers are expanded to 100 pins by replacing the standard DIL48 module with PEP3000 module. ·  Local Storage Media through PCMCIA Slot, Compact FLASH Card (Optional) ·  Standard Package : Main unit, DIL 48 Module, AC Adapter, CDROM, User's Guide, USB Cable. ·  Optional Accessories : PEP3000 Pin-driver Expansion Pack, Package Adapter, CF Card. ·  Advanced hardware features minimized Bounce noise. Only IC manufacturers approved algorithms are adopted. ·  Supports 22800+ devices from up to 100 IC manufacturers including MEMORY, MCU, PLD. ·  Free life-time software update. ·  Three working modes: PC-hosted mode via USB port for R&D, Stand-alone mode for production, Terminal mode for customer application. ·  Pin continuity and wrong chip insertion check prevent chips from accidental damage ·  Over-current and over-voltage protection for programmer hardware. ·  Clustering programming system, a characteristic volume production solution. Several units work together in stand-alone mode like a multi-site production programmer. Advantages over traditional gang programming: ·  No special gang adapter and s/w are needed. Supports more devices and algorithms update more quickly. ·  Meets budget flexibly. Starts with a single unit, then, add more to increase throughput with business growing. ·  Safer for the production chain because a single unit faulty will not stop whole production. ·  Higher throughput. Each unit starts working as soon as a new chip is inserted, No need for synchronous start of all the units. ·  Programs and Verify 32MB Flash Memories within 18 Seconds. ·  Up to 100 Pins Universal Pin-drivers. ·  Supports 21 ,000+ Devices including 1.5V devices. ·  High Programming Quality ·  PC Hosted (USB), Stand-alone and Terminal Three Modes in One Unit. ·  Powerful and Intelligent Software ·  Operator friendly control software combines many powerful functions with ease of use. ·  Down to 1.5V low voltage devices are supported directly. ·  Software supports WINDOWS 98/ME/NT/2000/XP.