Steam Power Plant

Steam Power Plant The Experimental steam power plant setup is designed to study power generation using steam & evaluate performance of the power plant. The setup consists of Diesel fired boiler, steam turbine, steam condenser & power generator. The steam is generated in the boiler  is supplied to the turbine & after expansion it flows to the condenser. The condensate is extracted from condenser using extraction pump. The condenser is cooling water is supplied from a large sump tank using a centrifugal pump. An AC alternator is coupled to the generator & power generated is supplied to a load bank of electric heaters. Measuring instruments are provided to measure the pressure & temperature of steam at different points in the cycle. The amount of boiler feed water, condensate & fuel consumption of the boiler are also measured for measurement of boiler efficiency & turbine performance. We offer Steam Power Plant in 1 kW & 3 kW Output capacities. TECHNICAL SPECIFICATIONS:  Water Tube Steam Boiler - 300 Kg/hr operating pressure 10 bar, Diesel Fired, Make - Thermax Steam Separator Steam Turbine – 1 kW @ 3000 RPM Steam Condenser: Shell & Tube Condenser AC Alternator – 1 kW Water Softener Separating & Throttling calorimeter Fuel Tank Condensate Measurement Tank Condensate Extraction Pump Condenser Cooling Water Circulation Pump Pressure Gauges Chimney Water Meter Steam Solenoid Valve Control Panel with following instruments & equipment – - Load bank  - RPM Controller & RPM Sensor - Temperature  Indicator - Temperature Sensors Type K Thermocouples - Heater On Off Switch - Pump Starter - Mains On/OFF - Mains Indicator NOTE: We also offer Steam Power Plant with 3 kW Turbine Output & 600 Kg/hr Steam Boiler